z1
This item can be selected when a Dolby TrueHD signal is played.
z2
This item can be selected when Dolby TrueHD, Dolby Digital or DTS signal is played.
z3
This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z4 This setting is available when the set sound mode name contains “+PLgz”.
z5
During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z6 This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 196)
z7 This setting is unavailable when the set sound mode name contains “+PLg Music” or “+Neo:X Music”.
z8
This setting is possible when the sound mode is “Cinema” mode.
z9 This item cannot be set when “Dynamic EQ” is set to “On”. (v
p. 160)
z10
This item cannot be set when Audyssey
®
Setup (Speaker Calibration) has not been performed.
z11
This item cannot be set when “MultEQ
®
XT” is set to “Off”. (v
p. 159)
z12
This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
Contents Connections Playback Settings Tips Appendix
251
Front panel Display Rear panel Remote Index
To Next Page
Loading...
