0
The analog audio signal and the 2-channel PCM signal input from HDMI connector or digital connectors (OPTICAL/COAXIAL) can be played back in ZONE2.
0
If you want to play back HDMI signals other than 2-channel PCM in ZONE2, set “HDMI Audio” to “PCM”. (v
p. 253)
2-channel PCM signals are output from a device connected to the input source selected for ZONE2 and can be played back in ZONE2.
In this case, the MAIN ZONE audio will also be converted to 2-channel PCM signals if the MAIN ZONE and ZONE2 are set to the same input source. However, depending on
the playback device, the playback signal may not be converted to PCM even if this setting is configured.
0
The analog audio signal and the 2-channel PCM signal input from digital connectors (OPTICAL/COAXIAL) can be played back in ZONE3.
0
When “Component Video Out” in the menu is set to “ZONE2”, the component video output connector outputs the ZONE2 video. (v p. 202)
0
The menu screen is not output in ZONE2.
Contents Connections Playback Settings Tips Appendix
169
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
