Denon DHT-M330DV - 19 SPECIFICATIONS

57
ENGLI
19
SPECIFICATIONS
2 Audio Section
• Power Amplifier Section
Rated output: Front: 17 W + 17 W (6 Ω/ohm load, 1 kHz, T.H.D. 10 %)
Center: 20 W (6 Ω/ohm load, 1 kHz, T.H.D. 10 %)
Surround: 17 W + 17 W (6 Ω/ohm load, 1 kHz, T.H.D. 10 %)
Subwoofer: 20 W (6 Ω/ohm load, 1 kHz, T.H.D. 10 %)
Output terminals: Speaker impedance: 6 to 16 Ω/ohms
• Analog Section
Input sensitivity/Input impedance: 400 mV/47 kΩ/kohms
Frequency response: 10 Hz to 50 kHz: +0, –3 dB (LINE, Direct mode)
Signal-to-noise ratio: 90 dB (LINE, Direct mode)
2 Tuner Section
Reception frequency range: FM:
87.5 MHz to 108 MHz AM: 522 kHz to 1611 kHz
Receiving sensitivity: FM: 1.8 µV/75 Ω/ohms AM: 20 µV
FM stereo separation: 35 dB (1 kHz)
• Digital Section
Digital input/output: Format — Digital audio interface
2 Timer Section
Timer: Sleep timer: 120 minutes, maximum
2 General
Power supply: 230 V AC, 50 Hz
Power consumption: 75 W (At standby: Approximately 1 W)
Maximum external dimensions: 210 (W) x 70 (H) x 325 (D) mm (including feet, knobs, and connectors)
Weight: 3.9 kg
2 Remote Control Unit RC-996
Remote control method: IR pulse method
Power supply: 3 V DC, using two AA batteries
2 Speakers SYS-M330
• Satellite speaker system (SC-AM330)
Type: 2-way, 2-speakers / Closed box / Low-leakage-flux
Speakers: 5.7 cm cone bass-mid x 1
2,5 cm super-high range x 1
Input impedance: 6 Ω/ohms
Max. input: 30 watts (IEC)
80 watts (PEAK)
Dimensions: 79 (W) x 140 (H) x 123 (D) mm
Mass: 0.7 kg
• Center speaker system (SC-CM330)
Type: 2-way, 3-speakers / Closed box / Low-leakage-flux
Speaker: 5.7 cm cone bass-mid x 2
2,5 cm super-high range x 1
Input impedance: 6 Ω/ohms
Max. input 30 watts (IEC)
80 watts (PEAK)
Dimensions: 210 (W) x 79 (H) x 133 (D) mm
Mass: 1.0 kg
• Subwoofer (DSW-3L)
Type: 1-way, 1-speaker / Reflex box / Low-leakage-flux
Speaker: 16 cm cone woofer x 1
Speaker impedance: 6 Ω/ohms
Frequency range: 30 Hz ~ 240 Hz
Max. input 60 watts
Dimensions: 210 (W) x 322 (H) x 304 (D) mm (including base)
Mass: 4.9 kg (including base)
✽ Design and specifications are subject to change without notice in the course of product improvement.