Denon DHT-FS3 - User Manual

Other manuals for Denon DHT-FS3

Specifications2 pages

Questions and Answers

A
Amanda BaileyJul 31, 2025
What to do if my Denon DHT-FS3 Home Theater System power indicator lights but no sound is produced?
- J
  Jennifer HarveyJul 31, 2025
  If the power indicator is on but you're not getting any sound from your Denon Home Theater System, there are several potential causes: * Ensure the speaker cables and analog connection cables are securely connected. * Verify you've selected the correct function (input). * Make sure the volume isn't turned down; increase it using the VOL+ button on the main unit or the VOLUME button on the remote. * Check that mute mode is off. * Confirm a digital signal is being input and that you've properly selected the digital signal input source.
K
Keith GarciaAug 7, 2025
Why is no DTS sound produced on my Denon DHT-FS3?
- A
  Amber CainAug 7, 2025
  If you're not getting any DTS sound from your Denon Home Theater System, here are a few things to check: * Ensure your DVD player’s audio output setting is set to bit stream or use the DVD player’s default settings. * Confirm that your DVD player is DTS-compatible; if not, use a DTS-compatible player. * Verify that the DHT-FS3’s input setting is set to digital input and the surround mode is set to “SURR”.
E
Eric WilsonAug 15, 2025
Why does my Denon Home Theater System remote control not operate?
- S
  Sharon WatkinsAug 15, 2025
  If your Denon Home Theater System's remote control isn't working, try these steps: 1. Replace the batteries with new ones. 2. Make sure you're operating the remote closer to the main unit. 3. Remove any obstacles between the remote and the main unit. 4. Check that the batteries are inserted correctly.
Q
qparkAug 23, 2025
How to fix a Denon Home Theater System when the power indicator doesn't light up?
- T
  Taylor BlackAug 23, 2025
  If the power indicator on your Denon Home Theater System doesn't light up and no sound is produced, the power supply cord’s plug may not be fully plugged in. Check the insertion of the power supply cord plug and connect securely.

Summary

IMPORTANT SAFETY INSTRUCTIONS

FCC INFORMATION

Getting Started

Cautions on handling

Important handling precautions before powering on the unit.

About the remote control unit

Installation

About front speaker unit installation

Mounting on a wall

About subwoofer installation

Connections

Connecting a DVD player

Guide for connecting a DVD player for optimal surround sound.

Connecting the TV

Guide for connecting the TV to enjoy surround-compatible digital broadcast programs.

Connecting an iPod

Instructions for connecting an iPod using the Control Dock.

Settings

Simple Setup

Initial setup procedure for the listening room and sound modes.

Detailed Settings

Operation

Playing the sound from the TV

iPod playback

Instructions for playing music from an iPod using the remote.

Listening with headphones

Playing the iPod

Detailed steps for controlling iPod playback using the remote.

Operating the remote control unit

Setting the preset memory function

Troubleshooting

Setting the punch through function

Specifications

Denon DHT-FS3 Specifications

General

Audio decoders	Dolby Digital, Dolby Pro Logic II, DTS
RMS rated power	110 W
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	100 dB
Satellite speaker frequency range	150 - 20000 Hz
Subwoofer frequency range	45 - 150 Hz
Subwoofer driver diameter (imperial)	6.23 \
Power consumption (standby)	1 W
Power consumption (typical)	32 W