ENGLISH
Getting Started Installation Connections Settings Operation Other functions
Operating the
remote control unit
n
Front speaker unit
Type: 1-way 6-speaker, enclosed, shielded type
Rated output:
22 W x 5 (6 Ω/ohms)
Subwoofer : 40 W (3 Ω/ohms load)
Input sensitivity
500 mV / 47 kΩ/kohms / 250 mV / 47 kΩ/kohms (selectable)
Frequency response: Front : 150 Hz ~ 20 kHz, DSW : 45 Hz ~ 150 Hz
S/N ratio: 100 dB
Power supply: U.S.A., Canada models : AC 120 V, 60 Hz
European models : AC 230 V, 50 Hz
Power consumption:
When power is on : U.S.A., Canada models : 37 W
European models
: 32 W
In standby : 1 W or less
Speaker units:
8 cm (3-5/32”) cone type x 6
Maximum external dimensions:
Without feet : 850 (W) x 96 (H) x 125 (D) mm
(33-15/32” x 3-25/32” x 4-59/64”)
With 25 mm (height) feet : 850 (W) x 111 (H) x 125 (D) mm
(33-15/32” x 4-3/8” x 4-59/64”)
With 35 mm (height) feet : 850 (W) x 121 (H) x 125 (D) mm
(33-15/32” x 4-49/64” x 4-59/64”)
Mass: 4.6 kg (10 lbs 2.26 oz)
n
Subwoofer
Type: 1-way 1-speaker, bass reflex type
Playback frequency range:
45 Hz ~ 150 Hz
Max. output:
40 W (IEC), 80 W (PEAK)
Input impedance: 3 Ω/ohms
Speaker units:
16 cm (6-19/64”) cone type x 1
Maximum external dimensions:
106 (W) x 380 (H) x 360 (D) mm (4-11/64” x 14-61/64” x 14-11/64”)
Mass: 5.6 kg (12 lbs 5.53 oz)
n
Remote control unit (RC-1074)
Remote control method: Infrared pulse method
Batteries: R6/AA Type (two batteries)
Maximum external dimensions:
52 (W) x 233 (H) x 21 (D) mm (2-3/64” x 9-11/64“ x 53/64”)
Mass: 160 g (Approx. 5.6 oz) (including batteries)
* For purposes of improvement, specifications and design are subject to change without notice.
Specifications
• A signal with a sampling
frequency of 96 kHz (not
compatible) has been input.
• Either switch to the input from a player with
a sampling frequency with which the set is
compatible, namely 32, 44.1 or 48 , or use analog
connections.
• The set’s internal circuitry is
not operating properly.
• Turn off the power, then turn it back on. If the
same error message is displayed again, contact
your store of purchase for repairs.
• The temperature inside the set
is too high.
• Turn off the power and wait for a while.
• There is a problem with the
speaker connections.
• Securely connect the speaker cables.
• Turn off the power, then turn it back on. If
is displayed again, contact your store of purchase
for repairs.
• The temperature inside the set
is too high.
• Turn off the power and wait
for a while.
Display
n
Messages:
20
ENGLISH
Troubleshooting Specifications
To Next Page
Loading...
