Need help?Do you have a question about the Denon DP29F - DP 29F Turntable and is the answer not in the manual?
General| Drive System | Belt Drive |
|---|---|
| Motor | DC Servo Motor |
| Signal to Noise Ratio | 60 dB |
| Cartridge | MM type |
| Weight | 2.8 kg |
| Frequency Range | 20 Hz - 20 kHz |
| Power Supply | AC 230 V, 50 Hz |
| Power Consumption | 2 W |
| Speed | 33-1/3 rpm, 45 rpm |
| Tonearm Type | Straight Tonearm |
| Dimensions | 360 x 97 x 357 mm |
| Output | 2.5 mV |
| Wow and Flutter | 0.15% (WRMS) |
Covers safe handling of the power cord, cleaning, and avoiding hazards from attachments and moisture.
Covers power sources, grounding, lightning protection, servicing, and replacement parts.
Ensure the unit meets local power requirements; consult an electrician if in doubt.
Guidelines to protect users from electric shock and injury, such as not touching plugs with wet hands.
Instructions for fitting the drive belt, installing the platter, and rotating it correctly.
Connect audio output PIN-plugs to amplifier jacks and the ground wire to the SIGNAL GND terminal.
Identifies and briefly describes all operational controls on the turntable.
Steps for placing a record, setting speed and size, and starting playback.
Solutions for problems like no power or the platter not turning.
To Next Page
