Denon DR-M22 - Page 10

¢ Switch on your amplifier or receiver.
«Set the TAPE MONITOR switch on your amplifier or receiver to the TAPE position.
¢ Operate the deck in numerical order as illustrated below:
e) POWER] Push the switch to turn “‘on’’ ( m) the power.
@ Load the cassette tape
a) Push the PLAY KEY
({ PLAY] lamp will light up)
PHONES] Playback sound is fed into
the headphone set
al a
STEREO CASSETTE BECK
OR~M2z
OUTPUT LEVEL
Check to make sure
the OUTPUT LEVEL
© [wonton]
Press this switch to the TAPE ( @ )
position.+(See page 13)
@ eq]
Press the EJECT button to open
the cassette compartment.
(1) [river]
Check to make sure that it
is turned “off"’.
© Dovey nA
For recordings made without Dolby NR, set to “‘off’’.
For recordings made with Dolby B NR, set to ‘‘on”’
and ‘‘B”.
Fig. 10 A ral made with Dolby C NR, set to ‘‘on
When
‘playback
is
finished,
press
the
stop
(IM)
key.
To
pause
during
playback,
press
the
PAUSE/MUTE
(i)
key.
To
restart
the
tape,
press
the
PLAY
(>
)
key.
If
different
types
of
Dolby
Noise
Reduction
are
used
for
record
and
playback,
playback
response
will
be
adversely
effected.
Note:
If
the
power
switch
is
turned
OFF
in
either
the
recording
or
playback
mode,
the
Cassette
cannot
be
removed,
even
if
the
EJECT
button
is
pressed.
Please
turn
the
power
switch
ON
again,
and
then
in
stop
mode,
press
the
EJECT.
button
to
remove
the
cassette
tape.
10s