Denon DR-M22 - Page 11

RECORDING
» Switch on the source component (tuner, amplifier, etc.) +
-
Set
the
TAPE
MONITOR
switch
on
your
amplifier
or
receiver
to
the
SOURCE
position.
©
POWER!
Push
the
switch
to
turn
‘‘on’’
(=)
the
power.
Load the cassette tape ;
(Make
sure
the
erasure
prevention
tab
has
not
been
removed
from
the
cassette shell haif.)
When pressed, the recording wiil start.
(The [>PLAY] and[OREC] lamps will tight up)
(eur CEvEL
s
Com
(Convenes toor tate taste]
DENON 5° sweao sien wecnamem
sveete CASSETTE CK
D
M) INPUT LEVEL
Used to set recording
jevel.>(See page 12)
@ Hea
Press the EJECT button
to
open
the
cassette
©
compartment.
MONITOR
Press this switch to the SOURCE ( )
position.+(See page 13)
@) [ven]
Check to make sure that it
is turned ‘off’.
© porsy AR]
Set, in accordance with the recording is made. For
recordings without Dolby NR, set to ‘‘off’’. For record-
ings with Dolby B NR, set to ‘‘on" and ‘'B’’. For
recordings with Dolby C NR, set to “on"” and ‘'C”’.
Future mistakes during playback can be avoided if the
cassette is so marked far Dolby NR encoded record-
ings.
RECORD KEY
; When pressed, the deck goes into the record standby mode.
Fig. 11 The {OREC] and [QOPAUSE/MUTE] lamps will light, and both
recording/playback and erase heads will come into contact
with the tape. Initial setting of recording levels should be
made in the record standby mode.
When recording is finished, press the STOP (MB) key.
mw Instant playback to recording mode
To
start
recording
right
after
previously
recorded
material
on
a
tape,
this
feature
is
quite
convenient.
1.
Play
the
section
of
the
tape
with
previously
recorded
program
material.
‘2.
When
the
previously
recorded
material
finishes,
press
both
the
RECORD
(@
REC)
key
and
the
PLAY
(p>
)key
at
the
same
time.
Without
stopping,
the
deck
will
go
from
the
playback
to
the
recording
mode,
and
the
lamp will go
on.
Caution :
Be
careful
not
to
erase
important
recordings
by
mistake.
Mis-erasing
can
be
avoided
by
following
the
two
steps
below:
1.
If
the
PLAY
(»)
key
is
pressed
while
the
[OREC ]lamp
is
on,
the
tape
will
be
recorded.
2. If the PLAY (») and RECORD (@REC) key are pressed at the same time, the tape will be
recorded.
ee i