Denon DR-M22 - Maintenance and Adjustments; Mechanism Section Adjustments and Checks

CENTRALIZED DISPLAY
fa PAUSE / MUTE
4- DIGIT COUNTER NR SYSTEM MONITOR TAPE SELECT FLUORESCENT PEAK METER
COUNTER MEMORY — DOLBY NR— MONITOR BIAS FIGE ADS
.
RESET. SrOE. COMPUTER SERVO MECHANISM off 2 TAPE
a || | SPLIT POWER SUPPLIED AUDIO AMPLIFIER
a on c SOURCE
Fig. 12
1) Operation of the Tape Counter
(1) Press the RESET button to reset the counter to “OOOO”.
(2) By using the PLAY, FF, or REW functions, the reading of the counter will change to
indicate index position.
eDuring recording and playback operations, the counter is useful for noting the location
of existing programs or positions where recording is to be started.
eWhen the power switch is turned “off”, the counter disolay turns off. When the deck
is turned back “on”, the counter is automatically reset to “OOOO”.
The reading of this counter does not correspond with that of any other deck.
2) Operation of MEMORY STOP
(1) During recording or playback operations, MEMORY STOP can be used to locate a par-
ticular point on the tape. At the desired point, reset the counter to “OOOO”. With the
MEMORY STOP button in the “on” position, the deck will stop at the “0000” point
(actually between “9995” and “OOO0O”) during REWIND operations.
(2) The MEMORY STOP indication will light when this function is activated.
(3) Notes: ©When the power is turned “off”, this function is automatically deactivated.
e The MEMORY STOP is accurate to —5 on the counter, and will stop between
“9995” and “OOOO”.
3) Display Functions
(1) The position of the tape in use is displayed automatically. NORMAL, CrOz, or METAL
indicators light in the display.
(2) If a blank space is to be made during recording, hold the PAUSE/MUTE key in. At this
time, the PAUSE/MUTE indicator in the display will flash in one-second intervals.
(3) The display features two-color lettering and indications for easy identification.
PROPER RECORDING LEVEL
A too high recording level can saturate the tape and cause distortion. On the other hand,
if recording levels are set too low, soft passages will be marked by residual noise. Proper
recording
level
is
the
single
most
important
factor
for
making
well
balanced
recordings.
= 12s