Notes concerning use of “Update” and “Add New Feature”
0
In order to add new functions, the environment and settings required
for connecting to broadband internet are needed. (v
p. 25)
0
Perform the add new feature operation after at least 2 minutes has
elapsed since turning this unit’s power on.
0
Do not turn off the power until updating or upgrading is completed.
0
Even with a broadband connection to the Internet, approximately 20
minutes is required for the updating/upgrading procedure to be
completed.
0
Once updating/upgrade starts, normal operations on this unit cannot
be performed until updating/upgrading is completed. Furthermore,
updating/upgrading the firmware may reset the backup data for the
parameters, etc. set for this unit.
0
When the update or upgrade failed with a message such as “Update
failed” and “Download failed”, remove and re-insert the power cord.
“Update Retry” appears on the display and update restarts from the
point at which update failed. If the error continues despite this, check
the network environment.
0
Information regarding the “Update” function and “Add New Feature” will be
announced on the Denon web site each time related plans are defined.
Reset
Perform this procedure if the display is abnormal or if operations cannot be
performed. Various settings are reset to the factory default values. Make
settings again.
Cancel: Values are not reset.
Reset factory defaults: Values are reset.
Contents Connections Playback Settings Tips Appendix
81
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
