Why is there no sound or distorted sound from my Denon CD Player?
If you're getting no sound or distorted sound from your Denon CD Player, start by adjusting the volume and checking that the speakers are connected correctly. Note that HDMI sound is not output during PURE DIRECT or when AUDIO MODE is set to “ANALOG.”
Why does my Denon DVD-1920 DVD Player have no sound or distorted sound?
If you're experiencing no sound or distorted sound with your Denon DVD Player, first adjust the volume. Then, check that the speakers are connected correctly. Note that HDMI sound is not output during PURE DIRECT or when AUDIO MODE is set to ANALOG.
What to do if my Denon CD Player has no sound or picture?
If you're experiencing no sound or picture with your Denon CD Player, verify that your TV is turned on and check the video and HDMI connections. Also, check the AUDIO/VIDEO cable connections to the TV. If using HDMI, and progressive signals are not output from the COMPONENT VIDEO OUT jacks, press the HDMI button on the front panel to set the HDMI output mode to OFF. Ensure that PURE DIRECT is set to “OFF,” and confirm that the VIDEO OUT mode is set correctly.
Technical details including output levels, impedance, and frequency response.
Guidelines to prevent injury from laser beam exposure during operation or servicing.
General safety warnings for product use and critical component replacement.
Procedures to verify compliance with safety standards after repair, including clearance and leakage.
Diagnostic flowcharts for identifying and resolving various operational faults.
Audio Outputs| analog output | 1 set (L/R) |
|---|---|
| multi channel output | 1 set (Front L/R, Center, Surround L/R, Subwoofer) |
| optical digital output | 1 |
| coaxial digital output | 1 |
| HDMI output | 1 |
CD Audio Specifications| frequency response | 4 Hz - 20 kHz |
|---|---|
| signal-to-noise ratio | 115 dB |
| dynamic range | 98 dB |
| total harmonic distortion | 0.004% |
Video Outputs| composite video output | 1.0 Vp-p (with 75 ohms load) |
|---|---|
| S-Video output Y | 1.0 Vp-p (with 75 ohms load) |
| S-Video output C | 0.286 Vp-p |
| component video output Y | 1.0 Vp-p (with 75 ohms load) |
| component video output Pb/Cb | 0.648 Vp-p (with 75 ohms load) |
| component video output Pr/Cr | 0.648 Vp-p (with 75 ohms load) |
| HDMI output version | 1.1 |
General Specifications| power supply | AC 120 V, 60 Hz |
|---|---|
| power consumption | 20 W |
| standby power consumption | 1 W |
| dimensions (W x H x D) | 435 x 75 x 310 mm |
| dimensions (W x H x D) inches | 17-3/32 x 2-61/64 x 12-13/32 inches |
| weight | 2.6 kg |
| weight in pounds | 5.72 lbs |
To Next Page
