EasyManua.ls Logo

Denon DVD-A11 - Differential Signal Data Pins; Configuration;Programming Pins; Control Pins; Power and Ground Pins

Denon DVD-A11
172 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
71
71
DVD-5900/DVD-A11
Differential Signal Data Pins
Pin Name Pin # Type Description
TX0+
TX0-
TX1+
TX1-
TX2+
TX2-
25
24
28
27
31
30
Analog
Analog
Analog
Analog
Analog
Analog
TMDS Low Voltage Differential Signal output data pairs.
These pins are tri-stated when PD# is asserted.
TXC+
TXC-
22
21
Analog
Analog
TMDS Low Voltage Differential Signal output clock pairs.
These pins are tri-stated when PD# is asserted.
EXT_SWING 19 Analog Voltage Swing Adjust. A resistor should tie this pin to AVCC. This resistor
determines the amplitude of the voltage swing. A 510 ohm resistor is
recommended for remote display applications. For notebook computers, 680 ohm
is recommended.
Configuration/Programming Pins
Pin Name Pin # Type Description
MSEN 11 Out Monitor Sense. This pin is an open collector output. The output is programmable
through the I
2
C interface (see I
2
C register definitions). An external 5K pull-up
resistor is required on this pin.
RESERVED 34 In This pin is reserved.
NC 7,8 NC These pins are not electrically connected inside the package.
Control Pins
These control pins allow configuration of the transmitter through the slave I
2
C port, which is required by HDCP.
Pin Name Pin # Type Description
ISEL/RST# 13 In I
2
C Interface Select. If HIGH, then the I
2
C interface is active.
SCLS 15 In DDC I
2
C Clock.
SDAS 14 In/Out DDC I
2
C Data.
CTL3 6 In External CTL3.
HTPLG 9 In Monitor Charge Input. This pin is used to connect to the DVI Hot Plug pin to detect
the presence of an attached monitor.
Power and Ground Pins
Pin Name Pin # Type Description
VCC 1,12,33 Power Digital VCC. Connect to 3.3V supply.
GND 16,35,64 Ground Digital GND.
AVCC 23,29 Power Analog VCC. Connect to 3.3V supply.
AGND 20,26,32 Ground Analog GND.
PVCC1 18 Power Primary PLL Analog VCC. Connect to regulated 3.3V supply.
PVCC2 49 Power Filter PLL Analog VCC. Connect to regulated 3.3V supply.
PGND1 17 Ground PLL Analog GND.
PGND2 48 Ground PLL Analog GND.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com

Table of Contents

Other manuals for Denon DVD-A11

Related product manuals