Denon DVD-A1UDCI - Entering the Test Mode; Selecting the Mode

19
DVD-A1UDCI
6. Test mode
6.1. Entering the test mode
The test mode is entered by pressing the 5 and 2 buttons simultaneously, plug the AC cord into a power outlet.
When the test mode is set, the “1” and “3” indicators light.
FL tube display when test mode entered
When the test mode is set, a color bar appears on the monitor.
6.2. Selecting the mode
• The following modes are available.
(1) Laser on/off (CD/DVD/BD) mode : T2
(2) Servo adjustment value display mode : T3
(3) Error rate (skew) measurement mode : T7
(4) Accumulated laser on time display mode : TC
(5) Track buffer output mode : TE
(6) Picking up No. display mode : TG
(7) Error log display mode : TH
(8) Test mode cancel : TI
q When the 9 button is pressed after entering the test mode, the display switches in the order: “T2, T3, T7, TC, TE,
TG, TH, TI, T2 …"
w When the 8 button is pressed, the display switches in the opposite order fromq above, starting from the current
position (for example, if currently at “TA”, it switches as follows: “T2, T3, T7, TC, TE, TG, TH, TI, T2 …”).
FL Display (The display part of 13 digits)
12345678910111213
TEST MODE
FL Display (The display part of 13 digits)
12345678910111213
T2 LaserOnOff
FL Display (The display part of 13 digits)
12345678910111213
T3 Servo Adj.
FL Display (The display part of 13 digits)
12345678910111213
T7 Error Rate
FL Display (The display part of 13 digits)
12345678910111213
TC LaserOnTim
FL Display (The display part of 13 digits)
12345678910111213
TE Track Buf
FL Display (The display part of 13 digits)
12345678910111213
TG OPU Number
FL Display (The display part of 13 digits)
12345678910111213
TH Error Log
FL Display (The display part of 13 digits)
12345678910111213
TI Test Exit