30
DVD-A1UDCI
(5) Once the update status reaches 100%, "Succeeded updating the firmware" is displayed and updating is completed.
(6) Once updating is completed, unplug the AC cord.
(7) Reconnect the AC cord to the outlet, wait 3 minutes, then unplug it.
At this time, no video signals are output from the HDMI terminal, even if the power is turned on.
2.4. Version check
(1) With no disc loaded in the set, plug the AC cord into the power outlet while pressing the 5 and 1 buttons on the
main unit simultaneously.
•"NO DISC" is displayed on the FL tube.
(2) Press remote contraller "3265".
(3) Press the Cursor buttons(d or f) on the remote control unit, check the "IP Ver XXXXXX" is displayed on the FL tube.
•XXXXXXX : Version of updated IP ROM
2.5. Service check
Play a Blu-ray disc (1080p/24) and check that the video output operates normally.
•Connect the TV and DVD-A1UD with an HDMI cable.
•There is no need to set the HDMI output resolution in order to check.
--- Cautions on Firmware Update ---
•When the firmware is updated, the DVD-A1UD's settings and picture adjustments may be reset. Make a note of the set-
tings before updating, and set them again after updating.
•Do not unplug the RS-232C cable or set the power to standby during updating.
•Normal operations are not possible during updating.
To Next Page
Loading...
