Denon M-CR612

No sound comes out
No sound is produced. Or sound is distorted.
0
Check the connections for all devices. (v p. 21)
0
Insert connection cables all the way in.
0
Check that input connectors and output connectors are not reversely connected.
0
Check cables for damage.
0
Check that speaker cables are properly connected. Check that cable core wires come in contact with the metal part on speaker terminals. (v p. 22)
0
Securely tighten the speaker terminals. Check speaker terminals for looseness. (v p. 22)
0
Check that the proper input source is selected. (v p. 36)
0
Adjust the volume. (v p. 36)
0
Cancel the mute mode. (v p. 36)
0
Check that the correct input source is selected when audio is being input to this unit from an external device. (v p. 36)
0
Check the digital audio output setting on the connected device. The initial settings may be off depending on the device.
0
No sound is output from the speakers, the subwoofer or audio output when headphones are connected. (v p. 14)
0
Do not input non-PCM signals, such as Dolby Digital and DTS. This causes noise and could damage the speakers.
0
To playback via a Bluetooth connection, perform pairing between this unit and the Bluetooth device. (v p. 45)
0
It may be that only speaker A or speaker B is selected. Make sure the speakers are correctly connected then push the SPEAKER A/B button to check.
(v p. 83)
Contents
Connections Playback Settings Tips Appendix
120
Front panel Rear panel
Remote control
unit
Index