2. Updating via USB-B (U0705)
2.1. Preparation
(1) Personal Computer (Install "
Denon_DriverSetup_x.x.x
" V0.1.0 or later.).
(2) USB cable (A type-B type).
2.2. Operations
(1) Connect the USB cable to the rear USB port and PC.
(2) Press the power button to turn on the power.
(3) Move the dedicated driver to the installed folder.
(If the installation location of the dedicated driver has not been changed, it is stored in
"
C:\Program Files\Denon\Denon_USB_Driver
". )
(4) Rename the binary le for USB update as shown below.
ModelName_DFU_MX25L4006E.bin
(Ex.) PMA1600NE_DFU_MX25L4006E.bin (Do not include a hyphen in the model name.)
(5) Start "
DenonUSBAudioDfu.exe
".
(6) Click "
Start
".
If the error message below is displayed, close the application and check that the renamed le name is
correct.
XXXXXX
(6)ーー→
XXX-XXX
(7) In "
Upgrade
", wait until "
Firmware upgrade nished successfully.
" is displayed.
(8) Press the "
Exit
"button to exit the application.
(9) Press the "
X
" button to turn off the power.
(10) Remove the USB cable.
5.3. Checking after update
(1) Connect the USB cable to this unit.
(2) Press the power button to turn on the power.
(3) Move the dedicated driver to the installed folder.
( If the installation location of the dedicated driver has not been changed, it is installed in
"
C:\Program Files\Denon\Denon_USB_Driver
" )
(4) Start "
DenonUSBAudioCplApp.exe
"
(5) Select the "Information" tab, and check that the model name and rmware versions are correct.
(6) Press the "Close" button to exit the application.
(7) Press the "
X
" button to turn off the power.
(8) Remove the USB cable.
(9) After updating the rmware, check the version.
See "1. Version Display Mode"
XXX-XXX
XXXXXX
←ーー(7)
←ーー(8)
←ーー(5)
←ーー(5)
(6)ーー→
XXX-XX
vX.XX
57
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
