(4) Select the le and click [OPEN].
File Name : PMA1600NE_XXXXXXX.mot
(5) The FilePath and ID are inputted automatically, and M16C/20 62 is automatically selected for the
MCU Type.
Click [OK].
ModelName_XXXXXX.mot
ModelName
_Software
ModelName
_XXXXXX
****************
(6) Click [Setting...].
(7) Select 57600 as the baud rate. (DO NOT select the rate other than 57600.)
Click [OK].
b
Once congured, the settings are retained.
If a problem such as a connection error occurs, setting will be required again.
59
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
