Denon PMA-1600NE - Page 39

G
Select the “PMA-1600NE
” format.
0
It is normally recommended to set the format to “384000.0 Hz” and
“2ch-32 bit Interger”.
.
u
PMA-1600NE
PMA-1600NE
H
Quit Audio MIDI Setup.
o
Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB-DAC port to connect this unit to a computer.
1
Press the input source select button (USB-DAC) to
switch the input source to
“USB-DAC”.
“USB-DAC” is displayed on the display of this unit.
Start playback on the computer’s player software.
The digital audio signal that is being input is shown as follows in the
display.
“USB: PCM
or
“USB: DSD
xxxxkHz” xxxMHz”
(xxxx is the sampling frequency.)
0
If the sampling frequency cannot be detected, “Unlocked
” will be
displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
Contents Connections Playback Settings Tips Appendix
39
Front panel Rear panel
Remote control
unit
Index
I
V
\
• •
Audio Devices
~ Bu ilt-In Microphone
9' 2 1 nl00lll "
Bu il t-In Out put Clock source: D &M Holdings Inc. In te rn ...
Oi n/2out ~ ◄ • )
+
Source: Default
Fo rmat: 38 40 00.0 Hz
44100.0 Hz
V ol um e 48000 .0 Hz
88200.0 Hz
96000.0 Hz
176400.0 Hz
192000.0 Hz
352800.0 Hz
705600.0 Hz
768000.0 Hz
Configure Spe ak e rs ...
I
V V \