Denon PMA-1600NE - Connecting and Playing Back from a Digital Device (Coaxial;Optical)

o
Audio signals that can be played back
See “D/A converter” (v
p. 51).
NOTE
0
Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
0
When this unit is functioning as a D/A converter, sound is not output from the
computer’s speakers.
0
If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
0
When an error occurs on the computer, disconnect the USB cable and restart the
computer.
0
The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
0
Use a cable that is 3 m or less to connect to the computer.
Connecting and playing back from a
digital device (Coaxial/Optical)
1
Connect digital device to this unit. (v p. 23)
2
Press the input source select button (COAXIAL or
OPTICAL 1/2) to switch the input source to
“COAXIAL”
or “OPTICAL 1/2”.
The digital audio signal that is being input is shown as follows in the
display.
“COAX:PCM
or
“OPT1:PCM
or
“OPT2:PCM
xxxxkHz” xxxxkHz” xxxxkHz”
(xxxx is the sampling frequency.)
0
If the sampling frequency cannot be detected, “Unlocked
” will be
displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
Contents Connections Playback Settings Tips Appendix
40
Front panel Rear panel
Remote control
unit
Index
I
V
\
I
V V \
-
0