Denver Instrument P-214 User Manual

Pinnacle Series
Operation Manual
TARE
U
ser: J. S
m
ith
g
Weigh
P
-1
1
4
M
a
x
1
2
0
g
d
=
0
.1
m
g
1
1
-0
3
-0
1
1
2
:0
0
:0
0
3
.5
2
7
8
1
o
z
100.0127
602631.1 Rev. A

Denver Instrument P-214 Specifications

General

Brand	Denver Instrument
Model	P-214
Category	Accessories
Language	English

Summary

Warnings and Safety Information

Installation Instructions

Leveling your Balance

Operation

Taring the Balance

Step-by-step guide on how to tare the balance, including the function of the TARE key.

Simple Weighing

Calibration

External Calibration Procedure

Internal Calibration Procedure (PI Series only)

Counting Mode

Entering count mode

Step-by-step guide on how to access and initiate the counting mode application.

Target/Percent Weighing Mode

Entering target mode

Instructions for entering the target/percent weighing mode and setting the target weight.

Beginning to percent weighing

Describes how to start percent weighing after setting the target, and how taring affects the reading.

Check Weighing Mode

Setting target high and low limits

Guide to setting upper and lower weight limits for check weighing to receive OK, HIGH, or LOW indicators.

Formulation

Entering formulation mode

Steps to enter the formulation application for weighing multiple components in one container.

Beginning a formulation

Instructions for starting a formulation, adding the first component, and subsequent measurements.

Animal Weighing

Entering animal weighing mode

Procedure to enter the animal weighing mode, which helps stabilize readings for moving subjects.

Beginning animal weighing

Statistics

Entering statistics mode

Environmental Settings

Adjusting Filter Settings

Internal Calibration (PI-Series only)

Restore Factory Defaults

System

Security

Details how to set a password to prevent unauthorized access to menus and calibration.

Cleaning and Maintenance

Troubleshooting