Denver DAB-35 - SETTING ALARMS (AC OPERATION ONLY); SNOOZE (AC OPERATION ONLY)

-7-
SETTING ALARMS (AC OPERATION ONLY)
1. Alarms can be switched on or off in standby mode. However, the alarm parameters can only be
set when the product is on.
2. To set or change alarm 1, press ALARM/SNOOZE button once, then press the SELECT button.
(F.10)
3. To set or change alarm 2, press the ALARM/SNOOZE button twice, then press the SELECT
button.
4. To exist alarm setting mode, press the ALARM/SNOOZE button again.
5. The alarm setup prompts you for the following parameters. Select a value for each parameter
by press ▼/▲ buttons, and then press the SELECT button to move on to the next parameter.
6. Parameters
„ On Time –Hours and minutes
„ Duration-15/30/45/60/90 minutes
If the alarm is not cancelled product returns to standby after this time period
„ Source- Buzzer/DAB/FM
If DAB or FM is chosen as the audio source you will also be prompted to select the last
played station or one of the preset station (if set)
„ Daily/Once/Weekends/Weekdays
Choose the days on which the alarm is active
Note: if you choose “Once”, you are prompted to enter the require date.
„ Volume – Press the TUN/CH▲ or TUN/CH▼ button to increase or decrease the volume
you desired. This is the volume the alarm will build up to. (Initially the alarm sounds at a
low volume and gradually gets louder to the set volume)
„ Alarm – Off/ On
l In all listening modes active alarms are indicated by displaying the relevant Alarm 1 and or
Alarm 2 icons.
l At the set time, the alarm will sound, quietly at first, then gradually building up to the set
volume. When an alarm sounds.
To turn alarms on or off in standby mode
l Press the ALARM/SNOOZE button, the display shows the current alarm status. To switch the
alarms on or off
l Press the ALARM/SNOOZE button repeatedly to cycle through four states as shown below
(F.11)
l To choose the display Alarm status, press the SELECT button to confirm
SNOOZE (AC OPERATION ONLY)
1. To temporarily silence a sounding alarm, press the ALARM/SNOOZE button once, you can
change the snooze period by repeatedly pressing the ALARM/SNOOZE button, Snooze periods
are 5 or 10 minutes. The radio returns to standby for the set time period with Snooze
countdown displayed. When the countdown reaches 0(zero) the alarm triggered again.
(F.12) (F.13)
Alarm 1 Setup
F.10
Alarm 1 : Off
Alarm 1 : Off
Alarm 1 : On
Alarm 2 : Off
Alarm 1 : Off
Alarm 2 : On
Alarm 1 : On
Alarm 2 : On
F.11