8-2 Checking/first 50 hours
(X) Replacement of engine oil
Replace the engine oil at 50 hours only first time and every 250 hours after second
time. (Excepting that the 30ESX unit should be at the interval of 500 hours.)
® Remove the engine oil drain plug and discharge oil completely. It can be
discharged easily when the engine is warm.
© After engine oil is discharged, tighten the plug firmly.
® Charge new engine oil from the oil filler until it reaches the notched line of the
"H" on the dipstick.
© After engine oil is supplied, run the engine for a few minutes. Check that oil is
supplied to the level between H and L .
(2) Replacement of engine nil filter element
Replace the engine oil filter at 50 hours only first time and every 500 hours after
second time.
Ш Remove the cartridge type element (cartridge)
using filter wrench.
© Clean the filter base. Coat the packing of new
cartridge with engine oil thin. Then, mount the cartridge.
■ When mounting, tighten the cartridge from
3/4 to 1 turn by using filter wrench after the
packing is fitted to the seal of the filter base.
put the filter-wrench
■ cartridge
drain plug
© After the element is replaced, run the engine
for a while. Then, check to see that oil is
supplied to the level between H and L.
Parts number of oil filter cartrid.
ye :
Model name Parts number manufacture Parts number of manufacture
DCA-30ESX
У06020 41214
ISUZU
897049-7081
DCA-40ESX Y06020 41217 ISUZU 113240-2322
- 56 -
To Next Page
Loading...
