EasyManua.ls Logo

Derbi GP1 125 E3 - Instructions for Starting the Engine with Electric Starter

Derbi GP1 125 E3
170 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Avviamento del motore Starting the engine
Anlassen des Motors
43
Istruzioni per lavviamento del
motore
(con accensione elettrica)
- Agire sulla chiave di accensione nella
posizione della destra
!.
- Tenere la manopola comando gas al
minimo.
- Agire sul comando freno posteriore o
anteriore. È molto importante, altri-
menti il motore non si avvia.
- Premere il pulsante di accensione
e
mantenerlo così fino a che il motore si
avii al primo tentativo.
- Il tempo necessario in cui deve pre-
mersi il pulsante per laccensione è, di
solito, da 1 a 2 secondi approssimati-
vamente.
Non tenere il motore avviato senza
bisogno. Partire subito.
Avviso!
00
Non effettuare queste operazioni in locli
chiusi perchè i gas di scarico sono
tossici.
In caso di difficoltà si può procedere come
di seguito indicato:
Instructions for starting the engine
(with electric starter)
- Put the key in the ignition lock and turn
to the right hand position
!.
- Keep the throttle twist grip in the slow
running position.
- Apply the front or the rear brake. This
is very important, because the engine
will not start without the brakes
applied.
- Press the starter button
, and keep it
pressed until the engine fires at the
first attempt.
- The time necessary to keep the starter
button pressed until the engine fires
will be approximately between 1 and 2
seconds.
Do not keep the engine running
unnecessarily. Start when you
need to go.
Warning!
00
Exhaust fumes are noxious: do not start
the engine in an enclosed place.
Possible causes for engine starting diffi-
culties and suggested action:
Hinweise zum Ingangsetzen
des Motors
(mit elektrischem Anlasser)
- Den Schlüssel in das Kontaktschloß
einführen und nach rechts in die
Position
!
drehen.
- Den Gasgriff in leerlaufstellung halten.
- Den Hebel der Hinter- oder
Vorderbremse betätigen. Dies ist sehr
wichtig, weil sich sonst der Motor nicht
in Gang setzt.
- Den Anlasserknopf
drücken und
gedrückt halten, bis sich der Motor beim
ersten Versuch in Gang setzt.
- Um den Motor anzulassen, muß der
Anlasserknopf gewöhnlich ca. 1 bis 2
Sekunden gedrückt gehalten werden.
Lassen Sie den Motor nicht unnötig
laufen. Fahren Sie sofort los.
Warnung!
00
NIE IN GESCHLOSSENEN RÄUMEN
STARTEN, WEIL DIE ABGASE GIFTIG
SIND
Bei Startschwierigkeiten kann wie folgt
vorgegangen werden:

Table of Contents

Related product manuals