Derbi GP1 125 E3 - Before Every Start-Up; After Every Washing; Every 2 Years

144
Maintenance schedule
TO BE CARRIED OUT BY THE USER BEFORE
EVERY START-UP
Engine and transmission
- ENGINE OIL: Check the level – top up if necessary
- COOLANT: Check the level – top up if necessary
Cycle
- BRAKE PADS: Check for wear – Renew if necessary
- TYRES: Check condition and pressure
- BRAKES: Check the correct operation
- Check for possible cracks in the fuel pipes
- Check for possible fluid leaks (petrol, oil, coolant, brake fluid,
gearbox oil)
Electrical
- CONTROL ELEMENTS: Check the correct operation
-LIGHTS: Check the operation of the mechanisms and the
correct functioning of the bulbs/LEDs
- HORN: Check its correct operation
TO BE CARRIED OUT BY THE USER
AFTER EVERY WASHING
Cycle
- BRAKE AND CLUTCH LEVERS: Lubricate
- BRAKES: Check the correct operation
Electrical
- LOCKS AND LIGHT SWITCHES: Apply anti-damp spray
EVERY 2 YEARS
Engine and transmission
- COOLANT: Renew
GP1 125 - SAS AIR FILTER: Clean Note 1
Cycle
- BRAKE FLUID: Change
- STEERING SHAFT: Clean and grease the bearings
1st SERVICE /RUNNING IN
Engine and transmission
- ENGINE OIL: Renew
- GEARBOX OIL: Renew
- OIL FILTER: Renew
- COOLANT: Check the level – top up if necessary
GP1 125 - IDLING RPM: Adjust
Cycle
- BRAKE LEVERS AND THROTTLE TWIST GRIP: Check the
correct operation and free play
- BRAKE PADS: Check for wear – Renew if necessary
-STEERING SHAFT: Check for absence of play – Adjust if
necessary
- TYRES: Check condition and pressure
Check for possible fluid leaks (petrol, oil, coolant, brake fluid,
gearbox oil)
- SAFETY TIGHTENING: Check
General
- FINAL CHECK: Carry out an on-road test drive, paying atten-
tion to the general operation of the brakes, steering, clutch, sus-
pensions, engine, lighting and instrument panel lights