EasyManua.ls Logo

Desa TUDOR - Page 22

Desa TUDOR
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.desatech.com
111986-01F22
PRESSURE TESTING GAS SUPPLY
PIPING SYSTEM


1. Disconnect replace and its individual
equipment shutoff valve from gas supply
piping system. Pressures in excess of 1/2
psig (3.5 kPa) will damage replace gas
regulator.
2. Cap off open end of gas pipe where equip-
ment shutoff valve was connected.
3. Pressurize supply piping system by either
opening propane/LP supply tank valve
for propane/LP gas replace or opening
main gas valve located on or near gas
meter for natural gas replace, or using
compressed air.
4. Check all joints of gas supply piping sys-
tem. Apply noncorrosive leak detection
uid to all joints. Bubbles forming show a
leak. Correct all leaks at once.
5. Reconnect fireplace and equipment
shutoff valve to gas supply. Check recon-
nected ttings for leaks.


1. Close equipment shutoff valve (see Fig-
ure 33).
2. Pressurize supply piping system by either
opening propane/LP supply tank valve
for propane/LP gas replace or opening
main gas valve located on or near gas
meter for natural gas replace, or using
compressed air.
3. Check all joints from propane/LP supply
tank or gas meter to equipment shutoff
valve (see Figure 34 or 35). Apply non-
corrosive leak detection uid to all joints.
Bubbles forming show a leak. Correct all
leaks at once.
FIREPLACE INSTALLATION
Continued
PRESSURE TESTING FIREPLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Fig-
ure 33).
2. Open main gas valve located on or near
gas meter for natural gas or open supply
tank valve for propane/LP gas.
3. Make sure control knob of replace is in
the OFF position.
4. Check all joints from equipment shutoff
valve to thermostat gas valve (see Figure
34 or 35). Apply noncorrosive leak detec-
tion uid to all joints. Bubbles forming
show a leak. Correct all leaks at once.
5. Light replace (see Operation, page 27).
Check all other internal joints for leaks.
6. Turn off replace (see To Turn Off Gas to
Appliance, page 27).
Open
Closed
Equipment
Shutoff Valve
Figure 33 - Equipment Shutoff Valve
Figure 35 - Checking Gas Joints for
Natural Gas Fireplace
Figure 34 - Checking Gas Joints for
Propane/LP Gas Fireplace
Propane/LP
Supply Tank
Gas Valve
Equipment
Shutoff Valve
Gas
Meter
Gas Valve
Equipment Shutoff Valve

Related product manuals