Deutronic DBL - General Safety Instructions

Deutronic DBL Manual (MPC4) - 14VDC - EN - 2 / 20 - 10 / 2006
Content
1)
General safety instructions ........................................................................................................ 2
2) Technical Data........................................................................................................................... 7
3) Connections and Control Elements ........................................................................................... 7
4) Initial Operation / Handling ........................................................................................................ 8
5) Operation Mode....................................................................................................................... 10
5. a) SUPPLYMENU – for power supply mode..................................................................... 10
5. b) CHARGEMENU – for battery charge mode.................................................................. 10
5. c) DEVICEMENU – for device specific parameter setting................................................. 12
6) Operation Mode / Status / Error Messages ............................................................................. 15
7) Annex – CELLCHECK / SHORT CELL DETECT .................................................................... 16
8) Annex – Indication / LED and Signal Lamp ............................................................................. 17
9) Annex – Characteristic Curves ................................................................................................ 18
10) Notes.................................................................................................................................... 19
11) Annex – Accessories............................................................................................................ 20
12) Service Center / Repair........................................................................................................ 20
Features:

Secure Flash mode for cars electronic
 All charging parameters configurable
 Comfortable menu guide
 Extensive protection functions and self-protection functions
 Short circuit and reverse polarity protection
 Switchable option to adjustable power supply
 Protection of on board electronical system
 Complete protective functions against defect batteries
 Reliable sparking suppression
 Sealed housing, protected against internal pollution
 Housing B/BM-Version advantageous for industrial production lines
Utilized and approved by well known automotive manufactures
1) General safety instructions
 The battery charger contains components which are likely to generate electric arcs and sparks, thus the
device has to be placed during operation in a special housing or in a room provided a for this purpose.
 Warning: When charging batteries explosive gases may occur. As a fact of that avoid fire, open light and
spark formation.
 Only charge batteries in well ventilated places.
 The battery charger is designed for professional applications for motor vehicle manufacturers and garages.
 The charger might only be utilised for the appointed applications.
 The battery which has to be charged must have a nominal capacity of 1Ah at minimum.
 It is only allowed to contact lead (Pb) batteries with 12 Volt nominal voltage.
 The battery charger is preset in a way that it is possible to charge batteries as much as possible in a short time -
for long-term applications it is necessary in any case to set the charging voltage to 14,2 VDC at maximum incl.
the use of CELLCHECK / SHORT CELL DETECT mode.
 It is not possible and not allowed to charge non rechargeable batteries with this device.
 Not on any account it is permitted to charge batteries in operation mode 'SUPPLYMODE'.
 Charging of fresh filled or defective batteries is explicitly forbidden.
 In any case pay attention to the guidelines of the battery manufacturer!
 Mains cables must always be in a proper state, renew defective cables immediately.
 The device mustn’t be opened because as well the test certification as the warranty expires.