Deutz TCD 2013 2V - Page 64

© 02/2010 OBJ_DOKU-21746-001.fm
1/4
6
Front cover
TCD 2013 2V W 01-02-02
Assembling/disassembling shaft sleeve on the crankshaft
(opposite side to flywheel)
Standard tools
– Packing compound
DEUTZ DW 74
– W 01-02-01
– W 01-03-01
– W 16-01-01
The following work procedure is described
for series 2012 as an example. The pro
-
cedure for the other engines listed above is
the same.
Installing the shaft sleeve
● Remove the crankshaft sealing ring.
 W 01-02-01
© 39876-0
● Visually inspect the crankshaft journal.
● Clean the crankshaft journal carefully.
● Repair unevenness with packing compound.
● Remove clamping bushing (1).
Unevenness such as running marks,
notches or very rough surfaces can cause
lubricating oil leaks between the crankshaft
and the shaft sleeve.
1
© 44875-0