2
Operation Manual
Cobra 1 Automatic Spraygun
Important
Read and follow all instructions and Safety Precautions before using this
equipment
CHARACTERISTICS
This automatic spray gun complies to ATEX regulations 94/9/EC, protection level II 2 G X, suitable to
use in Zones 1 & 2.
This Cobra 1 is a production spray gun suitable for use with automatic and semi-automatic machine in
conventional, HVLP or Trans-Tech application.
To handle a wide range of coating materials the material passages are manufactured from high grade
stainless steel.
Fluid tips and needles are available in high grade stainless steel.
Pressure feed material supply can be re-circulating or direct.
The needle adjustment knob has 18 ratchet positions, allows fine and accurate fluid flow control.
SPECIFICATIONS & MATERIALS OF CONSTRUCTION
Thread Pressure
Fluid inlet & recirculation “P”
1/4 BSP
Max 7 Bars
Air inlet (Atom+Fan) “A” “F”
1/4 BSP
Max 7 Bars
Cylinder/trigger “Cyl”
1/8 BSP
4 to 7bars
Maximum temperature in use
40° C
Spray gun weight
720 gms
Gun body
Aluminium hard anodized
Tip / Needle / Spray head
Stainless steel 303
EC Declaration of Conformity
We, ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the manufacturer of the
Spray gun model COBRA , declare, under our sole responsibility that the equipment to which this
document relates is in conformity with the following standards or other normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the protection requirements
of Council Directive 98/37/EEC relating to Machinery Safety Directive, and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective Systems intended for
use in Potentially Explosive Atmospheres protection level II 2 G X.
B. Holt, General Manager
24
th
April 2007
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
To Next Page
Loading...
