Need help?Do you have a question about the DeVilbiss Cobra 1 and is the answer not in the manual?
General| Fluid Adjustment | Yes |
|---|---|
| Type | HVLP |
| Nozzle Size | 1.3mm |
| Air Inlet Size | 1/4 inch |
| Material | Aluminum |
| Applications | Automotive |
Details the spray gun's compliance with ATEX regulations and its suitability for various applications.
Lists technical specifications and the materials used in the spray gun's construction.
States the manufacturer's declaration of conformity with relevant standards and directives.
Warns about flammable materials, ventilation, and static electricity risks.
Recommends specific PPE like respiratory protection, eye protection, and gloves.
Covers misuse, noise levels, and operating advice, including recoil forces.
Marks certain parts as optional accessories.
Guidance on connecting air and material hoses, including recommended sizes.
Details how to adjust atomizing air, fluid flow, and pattern size using control knobs.
Step-by-step guide for initial operation and basic troubleshooting of spray finish.
Procedures for replacing common wear-and-tear parts like the tip, needle, and packing seal.
Details on how to remove and replace the piston and O-rings.
Details optional kits for needle adjustment and remote control of air valves.
Refers to optional spray gun shaft and nut accessories.
Describes an optional indexed ring for air cap positioning.
To Next Page