72
INSTRUCTIONS FOR USE
INSTAFOLD™ POWERCHAIR
EN
presence of flammable gases, sources of heat or naked flames — risk of explosion / fire. Damaged
or worn upholstery increases the risk of fire hazard and should be replaced immediately.
• Individuals unable to drive the powerchair without assistance or supervision must not use the po-
werchair without such supervision. Unsupervised use of the powerchair must be avoided if there is
any doubt about the ability of an individual to operate it safely.
• Do not step on the foot pedal while loading or unloading from the powerchair. Risk of instability.
• If children, adults with learning diculties or pets pose a potential risk of tampering with the power-
chair, its suitability for use is to be considered during the initial user / product risk assessment.
• Do not use the InstaFold™ Powerchair while in freewheel (manual) mode. Always seek assistance if
freewheel mode is used. Do not use the powerchair in freewheel mode when on any slope.
5. TRANSPORT & STORAGE
Environmental conditions for transport and storage:
Ambient temperature: 0°C to +50°C
Humidity: <80% RH
Follow these conditions when transporting or storing the powerchair:
• Store the powerchair fully folded, on a flat, level floor (see section 8.3).
• Always fully charge, then remove the battery prior to long-term storage.
• The powerchair should be stored in clean and dry conditions. Cover to
protect from fluid ingress, dirt, dust etc.
• Powerchairs should not be stored on their side, their backs, or stacked.
• When transporting powerchairs by vehicle, they should be securely
stowed in the back of a van, truck, or boot of a car. Adjustable parts
should be removed or properly secured during transport.
• Keep the instructions for use with the powerchair or in a safe place.
Note: This vehicle is suitable for land and air transport, but contact your carrier in advance to determine their specific
requirements. The lithium battery pack may require special packaging and storage provisions in line with IATA or UN
Guidelines. To remove the battery, press the release button and then pull forward on the handle.
If your powerchair is stored for a prolonged period, flat spots may develop in the wheels, causing an uneven sensation
when driving. This should work itself out over time. Livewell Today Ltd. suggests placing a sturdy platform under the
frame to lift the wheels o the ground and take weight o the wheels during storage. If you notice flat spots after
continued use, replace the powerchair wheels immediately.
Caution
• Always lift your powerchair by the frame. Do not attempt to lift by any removable parts (e.g. seat or
armrests).
• Infrequently charged batteries, or batteries stored without a full charge are susceptible to perma-
nent damage, causing unreliable performance from your powerchair.
• Avoid placing the powerchair in direct sunlight — this could damage the electrical system and / or
cause label fading.
• Clean the powerchair in line with section 10 prior to storage.
To Next Page
Loading...