DeVilbiss drive InstaFold - Charging & Preparing for Use; Installation; Parts Identification

74
INSTRUCTIONS FOR USE INSTAFOLD™ POWERCHAIR
EN
7. PARTS IDENTIFIKATION
Push
Backrest
Joystick
Control Unit
Seat Base
Battery Case
Storage Bag
Suspension
Footrest
Front Wheel
Motor with
Mechanism
Drive Wheel
Frame
8. CHARGING & PREPARING FOR USE
8.1 Installation
Warning
• Before preparing the powerchair, ensure these instructions have been read and fully understood.
• Prepare the powerchair in a dry, indoor environment. Risk of electric shock if prepared in a damp
area.
• Only competent persons are to prepare the powerchair for use. If in doubt, contact Livewell Today
Ltd.
• Ensure a risk assessment in line with local health and safety policy is undertaken to ensure that sta
are not put at risk when performing assembly activities.
Refer to the Quick Start Guide for installation instructions (see section 18). Make sure to release the stopping pin holding
the anti-tip wheels in place on the inside of the rear wheels. Extend the anti-tip wheels and reposition the clip into the
3rd slot.
Warning
• The anti-tip wheels must be extended to the second or third positions during use. Anti-tip wheels are
included to reduce the risk of instability.