DeVilbiss FLG-G5 - Description of the Spray Gun; Product Specifications; Materials of Construction

2 © 2012 Finishing Brands UK Ltd.
Important
Read and follow all instructions and Safety Precautions before using this
equipment
Description
The FLG5 gravity spray gun is fitted with a 1.4 or 1.8mm nozzle for topcoat applications.
Alternative 2.0mm nozzle and needles are available for primer use. The FLG5 gravity-feed
spray gun is approved to ATEX regulations 94/9/EC, protection level;
II 2 G X. Suitable for use in Zones 1 and 2
Important: These spray guns are suitable for solvent-based coating materials. The design uses
EPA compliant atomising (Devilbiss Trans-Tech®) technology to reduce overspray and improve
coating efficiency. Nozzles and needles are manufactured in stainless steel. These guns are not
designed for use with highly corrosive and/or abrasive materials and if used with such materials
it must be expected that the need for cleaning and/or replacement of parts will be increased. If
there is any doubt regarding the suitability of a specific material contact your local Distributor or
Finishing Brands UK Limited direct.
Specification
Air supply connection - Universal ¼” BSP and NPS
Maximum static air inlet pressure - P
1
= 12 bar (175 psi)
Nominal gun inlet pressure with gun triggered - 2.4 bar (35 psi)
Maximum service temperature - 40°C
Gun weight - 640 g
Air flow - 277 l/min (9.8 cfm)
Materials of Construction
Gun body - Aluminium
Nozzle - Stainless steel
Needle - Stainless steel
Cup - Acetal and stainless steel
Finishing Brands UK Limited reserves the right to modify equipment specification without prior notice.
Example: Model Part No.
FLG-G5-14
Nozzle Size
1.4/1.8
EN