DeVilbiss Pro Lite E - Spray Pattern Troubleshooting: Other Issues; Ball End Heavy Patterns and Runs;Sags; Resolving Thin, Sandy Finishes

EN
Reduce air pressure and check
spray pattern.
Too much fluid flow.
Reduce air pressure.
Thin, sandy coarse finish drying
before it flows out.
Increase fluid flow by changing
fluid tip size, supply pressure or
turning needle control knob
counter clockwise.
Ball end heavy
pattern.
Too much air pressure.
Gun too far from surface.
Check distance.
Fluid flow too low.
Material too thin.
Too much atomisation air
pressure.
Gun too far from surface.
Check distance (normally 150-
200mm).
Excessive bounce-back.
Too much fluid flow.
Gun tilted at an angle.
Mount gun at right angle to work.
Adjust gun or reduce fluid
pressure.
Change fluid tip for smaller size
or change air cap for different
specification air cap.
Mix properly or apply light
coats/reduce fluid flow.
Runs and sags.
SB-E-2-855 R1.0
19/24