devinci TROY 8402 - ASSEMBLY AND CLEANING INSTRUCTIONS; CARBON FRAME SPECIFICATIONS; ALUMINIUM FRAME SPECIFICATIONS; FRG ADJUSTABLE TECHNOLOGY

CLEANING INSTRUCTIONS:
IT IS A WELL KNOWN FACT THAT A CLEAN BIKE PERFOMS BETTER. DEVINCI RECOMMENDS WASHING YOUR
BIKE REGULARLY USING A BRUSH AND SOAPY WATER. HOWEVER, DEVINCI DO NOT RECOMMEND THE USE OF
A PRESSURE WASHER, SINCE THIS MAY SIGNIFICANTLY REDUCE THE SERVICE LIFE OF BALL BEARINGS. EVEN
THOUGH OUR BALL BEARINGS ARE EQUIPPED WITH HIGH QUALITY DOUBLE-LIP SEALS, HIGH PRESSURE WATER
CAN STILL PASS THESE SEALS AND REMOVE THE GREASE INSIDE THE BEARING. THIS MAY CAUSE P
REMATURE
CORROSION AND WEAR OF THE BALL BEARINGS.
ASSEMBLY INSTRUCTIONS:
1- THOROUGHLY CLEAN THE INTERIOR OF EACH BEARING HOUSING TO REMOVE ANY DIRT OR OLD GREASE;
2- APPLY HIGH QUALITY WATERPROOF GREASE ON THE INSIDE FACE AND INSIDE DIAMETER OF ALL BEARING HOUSINGS
BEFORE PRESS-FIT;
3- APPLY HIGH QUALITY WATERPROOF GREASE TO ALL PIVOT PARTS THAT CONTACT WITH THE INNER DIAMETER OF THE
BEARINGS (EX.: MFP12021);
4- APPLY HIGH QUALITY WATERPROOF GREASE TO ALL NON-THREADED METAL-TO-METAL INTERFACES (EX.: PLANAR FACE
OF THE
PIVOT SPACER (MFP11080) THAT CONTACTS THE LATERAL FACES OF THE FRONT TRIANGLE WL PIVOT). THESE
INSTRUCTIONS ALS
O APPLY TO THE SHOCK ASSEMBLY;
5- UNLESS OTHERWISE SPECIFIED, APPLY BLUE LOCTITE 242 ON ALL THREADS BEFORE ASSEMBLY TO THE SPECIFIED
TORQUE VALUE;
6- HUB OPTIONS: YOU CAN SWITCH FROM A 142mm TO A 135mm HUB SIMPLY BY REPLACING THE PARTS MFP11031 AND
MFP11032 BY THE PARTS MFP11061 AND MFP11062;
7- TO PREVENT DAMAGE TO THE FRAME, THE SEATPOST MUST HAVE A MI
NIMUM INSERTION IN THE SEAT TUBE.
CARBON FRAME
:
SMALL / MEDIUM - 70mm INSERTION
LARGE / X-LARGE - 100mm INSERTION
ALUMINIUM FRAME
:
SMALL / MEDIUM / LARGE / X-LARGE - 100mm INSERTION
8- FRG ADJUSTABLE
: THIS DESIGN ALLOWS RIDERS TO CHOOSE BETWEEN A LOW OR HIGH POSITION. WITH FRG
ADJUSTABLE TECHNOLOGY, YOU CAN FINE-TUNE YOUR RIDE TO PERSONAL TASTES OR SPECIFIC TRAIL TYPES USING A
FLIP-FLOP PIVOT MECHANISM THAT SLIGHTLY CHANGES THE BIKE'S GEOMETRY FOR THE TROY, THIS ADJUSTMENT IS
PROVIDED BY THE BL PIVOT ADJUSTER SHAFTS AND SPACERS (MFP12023 AND MFP12022), AS SHOWN BELOW.
HIGH POSITION
LOW POSITION
2015 TROY ALU-CARBON