▪ Do not discard the magnets and plastic
rivets in the tank. Otherwise, the
dehumidifier cannot be started, or the
machine will not automatically stop
working when the water tank is full, and
the condensed water overflow will damage
the floor of the room.
▪ Please make sure to clean the condensed water in the tank and put the tank in its correct
operating position.
▪ If the water tank is dirty, please rinse it with clean water. Avoid using detergents, steel wire balls,
chemical dust removers, diesel, benzene, diluents or other solvents. These products can
damage the tank and cause leaks.
▪ Put the water tank in its original position. Otherwise, the indicator light will be red, and the
machine will start working again.
1. Take out the PVC pipe, straighten the drainpipe.
2. Insert one end of the drainpipe into the drain outlet at the top of the tank and connect the other end
to the bathroom, floor drain, outdoor or bucket like container.
To Next Page
Loading...
