19 Security in the dLAN
devolo dLAN 200 AVmini
4.2 dLAN 200 AV network encryp-
tion using the dLAN Configura-
tion Wizard
When using dLAN 200 AV adapters without encryption
buttons, data encryption can only be set up using the
dLAN Configuration Wizard. Start by updating the firm-
ware (see 3.4.1 Firmware update) of the dLAN 200
AV adapters.
After successfully installing the devolo software, you
can launch the dLAN Configuration Wizard via the
Start Programs devolo program group and the
Device Start dLAN Configuration Wizard of the
devolo Informer.
Before beginning with this step, make a note of the se-
curity IDs of all existing dLAN adapters. This unique
identifier of each dLAN device is located on the label of
the housing. It consists of 4 x 4 letters separated by da-
shes (e.g. ANJR-KMOR-KSHT-QRUV). Ensure that all
dLAN adapters are connected to the power grid and
computers or other network components as appropria-
te.
If the dLAN Configuration Wizard cannot
find a dLAN device in your network even
though one is plugged tightly into a power
outlet, follow the instructions for bandwidth
optimisation in the Appendix.
Configuring your dLANs using the dLAN Configuration
Wizard consists of three steps:
Scan for local adapter
After launching the wizard, it initially scans for a dLAN
adapter connected directly to your computer.
Entering a network password (fig. 7)
If your dLAN adapter has been found that is reachable
directly from your computer, you can select a network
password in the next step to be valid for this and all
other specified adapters in your personal home net-
work.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
