Devolo dLAN 200 User Manual

14 Initial use
devolo dLAN 200 AV USB extender
If not already detected by your operat-
ing system, install the relevant driver
for your USB device in accordance with
the respective manufacturer's instruc-
tions.
햴 After you have successfully installed the complete
software, continue by installing the
dLAN 200 AV USB extender hardware. (see 3.5
Connecting the dLAN 200 AV USB extender)
3.5 Connecting the
dLAN 200 AV USB extender
This section describes how to connect your
dLAN 200 AV USB extender to a USB device in your
dLAN 200 AV network.
The dLAN 200 AV USB extender is in-
tended for connection to devices such
as (multifunctional) printers or hard
drives. The adapter only ever supports
one USB device.
햲 Connect the dLAN 200 AV USB extender to the
USB device to be connected within your dLAN 200
AV network using a USB cable at the USB port.
햳 Plug the dLAN200AVUSBextender into an
available power outlet.
When connecting an external USB hard
drive, delayed hardware detection may
occur depending on the manufacturer,
due to the automatic hard drive test.
This may take a few minutes.
햴 Once you have connected a
dLAN 200 AV USB extender and another devolo
dLAN 200 AV adapter, your dLAN 200 AV net-
work has been set up.
You can find information on the respective
devolo dLAN 200 AV adapter on our website
www.devolo.com
.
In chapter 4 dLAN network you can find out
쑗 how to protect your dLAN 200 AV net-
work individually and
쑗 how to control access to the USB devices
connected via the
dLAN 200 AV USB extender.

Devolo dLAN 200 Specifications

General

Interface	Ethernet / WLAN
Connectivity technology	Wired & Wireless
Ethernet LAN (RJ-45) ports	3
Chipset	-
Internal	No
Product color	White
LED indicators	Yes
Modulation	1024-QAM, 256-QAM, 64-QAM, BPSK, OFDM, QPSK
Wi-Fi band	Single-band (2.4 GHz)
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology	10/100BaseT(X)
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
Security algorithms	WEP, WPA, WPA2
Networking standards	IEEE 802.11b, IEEE 802.11e, IEEE 802.11g, IEEE 802.11n, IEEE 802.3u, IEEE 802.3x
Spread spectrum method	DSSS
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	200 Mbit/s
Maximum operating distance	300 m
WLAN data transfer rates supported	300 Mbit/s
AC input voltage	230 V
AC input frequency	50 Hz
Dimensions (WxDxH)	110 x 68 x 49 mm
Non-operating relative humidity (non-condensing)	10 - 90 %
Input current	0.13 A
Power consumption (typical)	5.6 W
Storage temperature (T-T)	-25 - 70 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Depth	68 mm
Width	110 mm
Height	49 mm
Weight	200 g