Devolo Giga Bridge - Page 20

Introduction 20
devolo Giga Bridge
* Information about the web interface can be
found in Chapter 4 Configuration.
**Depending on the configuration, a
devolo Giga Bridge adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface. As soon as the network device
(e.g. computer) connected to the network inter-
face is switched on again, your devolo Giga Bridge
adapter can also be accessed again.
Check whether the adapter is connected to
the mains supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer to 3.3 Pairing – Establishing a G.hn
connection.
5White
LED
Lights up steady The connection does not have any issues
and the devolo Giga Bridge adapters
are ready to operate.
Can be disabled
6White
LED
Flashes at inter-
vals of 0.1 sec.
on/ 3secoff
The devolo Giga Bridge adapter is in
standby mode.**
Can be disabled
7Red and
white
LED
Flashes at inter-
vals of 0.1 sec.
on/2sec. off
The data transmission rate is not in the
optimal range (PHY rate below 1Gbps)
Cannot be disabled
8Red and
white
LED
Flashes at inter-
vals of 0.5 sec.
red/0.5 sec.
white
The devolo Giga Bridge adapter is carry-
ing out a firmware update.
Cannot be disabled
G.hn
LED
Flashing behav-
iour
Meaning LED status display
(web interface*)