Devolo Giga Bridge - Connecting the NT;ONT and devolo Giga Bridge

25 Initial use
devolo Giga Bridge
same mode to enable integration of new
devolo Giga Bridge adapters.
3.3.1Manual triggering the pairing of a
devolo Giga Bridge adapter
1 Plug the devolo Giga Bridge adapter into an
available power socket and press the G.hn/
Reset button of an existing devolo Giga Bridge
adapter in network for approx. 1 sec.
2 The new devolo Giga Bridge adapter pairs
automatically so no button needs to be
pressed. The LED of this adapter now also
flashes white.
After a short time (within three minutes),
the flashing LED becomes a steady white
light. The devolo Giga Bridge adapters
have successfully established a network.
3.4 Connecting the NT/ONT and
devolo Giga Bridge
The data connection of the NT/ONT and router can
take place over a coaxial (SAT/TV) or telephone
cable.
Wiring using a telephone line
In most cases, there is no additional (decoupled)
TAE socket near the demarcation point. This means
that here, for example, a network jack with an insu-