Devolo Magic Series User Manual

17 Introduction
devolo Magic 2 LAN
1-1
* Information about the web interface can be
found in Chapter 4 Configuration.
** Information on improving the transmission rate
can be found in Chapter 5.2 Bandwidth optimi-
zation.
***A devolo Magic adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface. In this mode, the devolo Magic
adapter cannot be accessed over the electrical wi-
ring. As soon as the network device (e.g. computer)
connected to the network interface is switched on
again, your devolo Magic adapter can also be ac-
cessed over the electrical wiring again.
Check whether the adapter is connected to the
mains supply correctly and whether the pairing
operation has been carried out successfully. For
more information about this, refer to 3.3
Connecting the devolo Magic 2 LAN
1-1
.
2.3.2Network connection
You can use the network connection on the
devolo Magic adapter to connect it to a PC or tele-
vision using a standard network cable.
2.3.3Integrated electrical socket
Always use the integrated electrical socket on the
devolo Magic adapter when connecting other
consumers to the mains supply. In particular,
electronic devices with mains adapter can negati-
vely affect PLC performance.
The integrated mains filter in the devolo Magic ad-
apter filters any such external interference and re-
duces any impairment of PLC performance.

Devolo Magic Series Specifications

General

Type	Powerline adapter
MIMO	Yes
Operating Voltage	100-240 V
Operating Frequency	50/60 Hz
WiFi Standard	IEEE 802.11ac
Maximum Speed	1200 Mbps
Ports	1 Gigabit Ethernet
Encryption	128-bit AES
Standards	IEEE 802.3
Frequency Band	2.4 GHz / 5 GHz