Devolo MicroLlink - Basic Controlling; Additional Controlling

|
Control commands
11
|
devolo MicroLink ISDN i
|
EN
2.3.1 Basic controlling
2.3.2 Additional controlling
Configuration Commands and register
Additional commands
and register
Basic modem initialisation AT&F
Control of connection estab-
lishment (dial-up)
ATD, ATP, ATT, ATX AT$D, AT:D, S6, S7, S8, S14
(Bit 6)
Answering of incoming call,
line acceptance, hang up
ATA, ATD, ATH, AT&D2, S0 AT-H, AT\T, S14.6, S28 (Bit
7)
Switch between command
and transmission phase
+++, ATO S2
Control of call signaling ATL, ATM
Selection of modem
information
ATI, ATS, AT&V AT%R, AT\S, AT%V, S86
Control of error correction AT+ES
Control of dial lock or dial
delay
S31 (Bit 7)
Configuration Commands and registers
Additional commands
and registers
Working with stored initialisa-
tions
AT&V, AT&W, AT*W, AT&Y,
ATZ
Special controlling
Control of modem signaling
lines
AT&C AT\D, AT&S
Control of DTR effect AT&D AT$D, AT:D, S28 (Bit 7)
Control of modem answers ATE, ATQ, ATV, AT\V AT&D, AT-H, AT-M, AT*Q,
S96
Control of dial tones AT&G
Control of data format S28 (Bit 0-1), S53