|
AT commands: Detailed description
31
|
devolo MicroLink ISDN i
|
EN
%V Display of firmware version
AT%V
This command is used to display the firmware version of the ISDN modem.
&V Display configuration profiles
AT&V
This command returns the current, as well as the two stored configuration
profiles, 0 and 1 (see also commands AT&W and AT*W) of the MicroLink
ISDN i.
\V CONNECT with error-free connections
AT\V0 : No modified CONNECT messages
AT\V1 : Identification of connections with
error correction
AT\V2 : Additional distinction of correction
processes
*AT\V8 : Detailed CONNECT messages
With the setting AT\V0, call establishment messages are issued in the CON-
NECT xxxxx form.
With the setting AT\V1, call establishment messages are issued in the CON-
NECT xxxxx/REL form.
AT\V2 provides additional information regarding the correction process in
the form of CONNECT xxxxx/REL-LAPB.
With the configuration AT\V8 the call establishment messages are issued in
the CONNECT xxxxx/ISDN/X75 form.
xxxxx stands for the speed with which the connection was established.
To Next Page
Loading...
