AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
32
EN
If the MicroLink ISDN i is configured to ATX0 or AT-M1, then the command
AT\V will have no effect on the plain text CONNECT messages.
&W Save configuration profile
AT&Wn : Save configuration profile n (n = 0, 1)
This command is used to save the current configuration of the MicroLink
ISDN i. All parameters that were set using AT commands, as well as a
number that were set using the S registers are saved. These values are pre
-
served when the modem is switched off.
Registers for which the current value cannot be saved using the command
AT&W are saved with their default values.
*W Save complete configuration profile
AT*Wn : Save complete configuration profile
n (n = 0, 1)
This command is used to save the current configuration of the MicroLink
ISDN i. All parameters that were set using AT commands and S registers are
saved. These values are preserved when the modem is switched off.
A configuration profile should be saved using the command AT*W.
X Handling of busy signals/CONNECT
messages
ATX0 : Busy signal returns NO CARRIER
ATX1 : Busy signal returns NO CARRIER
ATX2 : Busy signal returns NO CARRIER
ATX3 : Busy signal returns BUSY
*ATX4 : Busy signal returns BUSY
To Next Page
Loading...
