AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
16
EN
D Establishing a connection
ATDn
When this command is issued, the MicroLink ISDN i attempts to establish a
connection and dials the telephone number n. n may consist of the numerals
0 to 9, * and #. The maximum length for the complete dialing string is 36
characters, not including ATD. The following special characters may be
inserted; all other characters will be ignored:
The call establishment can be aborted at any time during the dialing process
by entering any character other than line feed, XON or XOFF.
$D Automatic dialing with DTR
*AT$D0 : Disables DTR dialing
AT$D1 : Enables DTR dialing
When DTR dialing is enabled and the condition of the control line switches
from OFF to ON, the MicroLink ISDN i establishes a connection to the number
Special characters Description
* or # External call
L
Sm
S=m or /m
Dialing of stored telephone numbers
Redial
Dial the number stored with AT&Z at location m
Dial the number stored with AT\P at location m
; Remain in command mode after dial string (for the addition of
further dialing commands in the event of excessively long dial
strings))
S Establishment of a semi-permanent connection (SPC) with a fol-
lowing 'S'
(Px)
(M+)
(M-)
(Mnr)
Defining ports and outgoing multiple subscriber numbers
Defining port 0 (V.24 interface)
Outgoing MSN displayed
Outgoing MSN not displayed
Define calling number specified in nr as outgoing MSN
To Next Page
Loading...
