Devolo MicroLlink - Escape Sequence

AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
28
EN
The command AT\F can be used to display and verify the stored numbers.
No further commands can be executed from the same command line after the
command AT\P.
Q Suppressing messages
*ATQ0 : Return of messages from ISDN modem on
ATQ1 : Return of messages from ISDN modem
off
ATQ2 : Messages off in answer mode
With this command, messages to the attached computer by the ISDN modem
can be completely suppressed (ATQ1) or suppressed in the answer mode only
(ATQ2).
*Q Message after return to transfer phase
*AT*Q0 : CONNECT message after invalid
escape sequence
AT*Q1 : No CONNECT message after invalid
escape sequence
The return of the CONNECT message can be suppressed after an invalid
escape sequence with this command.
\Q Data flow control on the serial port
AT\Q0 : No handshake
AT\Q1 : Bidirectional XON/XOFF handshake
AT\Q2 : Unidirectional CTS handshake