DeWalt D28710 Original Instructions

ENGLISH
11
• Secure the workpiece.
• Always set the spark deflector correctly.
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Do not apply excessive pressure to the
tool.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no-load condition.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Proper Hand Position (fi g. 5)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the
operating handle (c), with the other hand guiding the
workpiece.
Performing a Cut (fi g. 1)
1. Place the material to be cut against the fence (i)
and secure using the material clamp (j).
2. Turn the tool on and pull down the operating
handle (c) to cut the workpiece. Allow the motor
to reach full speed before cutting.
3. Allow the disc to cut freely. Do not force.
4. After completing the cut, switch off the tool and
return the arm to its upper rest position.
Switching On and Off (fi g. 1)
The on/off switch (a) is mounted in the operating
handle (c).
To run the tool, press the on/off switch (a).
Keep the on/off switch depressed while performing
the operation.
To stop the tool, release the switch.
The tool can be locked on for continuous use
by depressing the on/off switch (a) and then by
depressing the lock-on button (d). Hold the lock-on
button (d) as the on/off switch (a) is gently released.
To turn the tool off from the locked on position,
squeeze the on/off switch (a) and the lock-on button
(d) is released.
Do not unplug the tool with the switch locked on.
Make sure the tool is not locked on when plugging
in.
WARNING: Do not switch the tool on
or off when under load.
WARNING: Do not cut magnesium.
Transporting (fi g. 1)
The tool is equipped with a lock-down chain (u)
which locks the tool in closed-down position for
carrying.
1. Lower the guard (p) onto the cutting table (k)
and secure the tool in this position by hooking
the chain (u) over the lock-down hook (r).
2. Transport the tool using the carrying handle (e).
To release the tool, depress the operating handle (c)
slightly and release the chain.
MAINTENANCE
Your DEWALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
Lubrication
Your power tool requires no additional lubrication.

DeWalt D28710 Specifications

General

Quantity per pack	1 pc(s)