CODE
14
i5
16
POSSIBLE CAUSE
Unit operating in damp or humid conditions
Restricted air intake filter
Pump oil is low
18 Detergent type oil being used in pump
19 MOtor overload protection switch has tripped
2o Extension cord is wrong length or gauge
POSSIBLE SOLUTION
Move unit to a dry well ventilated area
clean or repiace air intake filter
Add SAE 40, non-detergent air compressor oil to pump. See
Compressor Pump Oil under Maintenance.
C0ntact a DEWALT fact0ry Service Center or a DEWALT
authorized service center:
Drain oil and refill pump with SAE 40, non-detergent air
compressor oil.
see Motor overload UnderFeaturesl
Check for proper gauge wire and cord length. See
Extension Cords under Installation.
21 LOOSeelectrical Connections contact a DEWALT factory servce Center or a DEWALT
I aUth0rized service center:
22 Possible defective motor or starting capacitor Contact a DEWALT factory service center or a DEWALT
authorized service center.
23 Pant sprayon nterna mot0r parts cQntact a DEWALT fact0ry service Centei era DEWALT
', authorized service center; Do not operate the c0mpress0r in
• the paint spray areal See flammable vapor warning.
21
To Next Page
Loading...
