DeWALT DCBL722 -Seal 2
NOTE: To ensure maximum performance and life of lithium-ion battery packs, charge the battery pack fully before
first use.
Charger Operation
Refer to the indicators below for the charge status of the battery pack.
DCB107, DCB112, DCB113, DCB115, DCB118, DCB132
Charging
DeWALT DCBL722 - Charging2
Fully Charged
DeWALT DCBL722 -Fully Charged2
Hot/Cold Pack Delay*
DeWALT DCBL722 - Hot2
* DCB107, DCB112, DCB113, DCB115, DCB118, DCB132: The red light will continue to blink, but a yellow indicator
light will be illuminated during this operation.
Once the battery pack has reached an appropriate temperature, the yellow light will turn off and the charger will
resume the charging procedure.
The compatible charger(s) will not charge a faulty battery pack. The charger will indicate faulty battery pack by
refusing to light.
NOTE: This could also mean a problem with a charger.
If the charger indicates a problem, take the charger and battery pack to be tested at an authorized service center.
hot/Cold Pack Delay
When the charger detects a battery pack that is too hot or too cold, it automatically starts a Hot/Cold Pack Delay,
suspending charging until the battery pack has reached an appropriate temperature. The charger then automatically
switches to the pack charging mode. This feature ensures maximum battery pack life.
A cold battery pack will charge at a slower rate than a warm battery pack. The battery pack will charge at that slower
rate throughout the entire charging cycle and will not return to the maximum charge rate even if the battery pack
warms.
The DCB118 charger is equipped with an internal fan designed to cool the battery pack. The fan will turn on
automatically when the battery pack needs to be cooled.
Never operate the charger if the fan does not operate properly or if ventilation slots are blocked. Do not permit foreign
objects to enter the interior of the charger.
Electronic Protection System
Li-Ion tools are designed with an Electronic Protection System that will protect the battery pack against overloading,
overheating or deep discharge.