EasyManua.ls Logo

DeWalt DCBL722 - Maintenance; Cleaning the Tool

DeWalt DCBL722
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DeWALT DCBL722 - Fig. H
Use (Fig. I)
CAUTION: Do not point unit discharge at self or bystanders.
CAUTION: Always wear safety glasses and hearing protection. Wear a filter mask if the operationis dusty.
Use of gloves, long pants, and substantial footwear is recommended. Keep long hair and loose clothing away from
openings and moving parts.
Install the battery pack 6 into the battery housing.
Hold the blow tube approximately 7 inches (180 mm) above the ground, turn the blower ON, and using a
sweeping motion from side to side, advance slowly keeping the accumulated debris/leaves in front of you as
shown in Fig. I.
DeWALT DCBL722 - Fig. I
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn the unit oand remove the battery pack before
making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye protection when performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These
chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild

Related product manuals