DeWALT DCBL722 -Fig. E
OPERATION
WARNING: To reduce the risk of serious personal injury, turn the unit off and remove the battery pack before
making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury.
WARNING: Do not operate the blower without a blow tube securely in place. Never reach down into housing
through tube hole.
WARNING: Always wear safety glasses. Wear a filter mask if the operation is dusty.
Use of rubber gloves and substantial footwear is recommended when working outdoors. Keep long hair and loose
clothing away from openings and moving parts. FOR HOUSEHOLD USE ONLY.
WARNING: Cut Hazard. When turning the tool off, wait 10 seconds for the fan to stop rotating
before removing the blower tube.
Always ensure the blower is switched OFF and the battery is removed when:
– You leave the blower unattended.
– Clearing a blockage.
– Checking, adjusting, cleaning, or working on the blower.
Only use a blower in daylight or good artificial light.
Installing and Removing the Battery Pack (Fig. F)
WARNING: Before removing or installing the battery, make certain the speed lock lever 2 is in the off position
to prevent switch actuation.
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack 6 into the tool handle, align the battery pack with the rails inside the tool’s handle and
slide it into the handle until the battery pack is firmly seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button 5 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger section of this manual.
To Next Page
Loading...
